WI1424A 1/06 | Page 11 |
TESTING THE SYSTEM
After installation is completed, test the system as follows.
1.Call the central station to inform them of the test.
2.Initiate an alarm, preferably on a zone that activates a steady siren, and verify proper signalling.
3.Call the central station to confirm their receipt of a good transmission.
Note: Be sure to test all enabled keypad panics.
Signal Strength Testing/Wireless Systems
To test the operation of wireless transmitters, proceed as follows.
1. Enter the
2. Fault a point of the transmitter to be tested by opening the loop. If the signal strength of the transmitter is
3 or greater, the keypad will beep, as follows:
Signal Power | Beeps |
0 | |
3 | 1 |
2 | |
3 | |
4 |
3. Restore the wireless point (close the loop).
The transmitter signal strength will be displayed on a scale of
Testing the System
LNAPCO Security Systems | X |