WI1424A 1/06 | Page 13 |
REMOTE BUS
NOTE: Refer to the EZM Installation Instructions for specific wiring information.
REMOTE BUS
|
| AVAILABLE DEVICES |
| AVAILABLE DEVICES |
| |
|
| 1. KEYPADS: | ||||
| ADDITIONAL | 2. | RP4 series, | |||
| 3. WIRED ZONE EXPANDER: |
|
|
| ||
| EZMs |
| (7 maximum) |
|
|
|
| 4. WIRELESS RECEIVERS: |
| ||||
|
| 5. RELAY MODULE: RM3008 | 2. |
| ||
|
| 6. VOICE INTERFACE: |
|
| EXPANDER: | |
|
| 7. TELEPHONE INTERFACE: WIZARD23. WIRED ZONE | ||||
| Example: |
| zones maximum) |
|
| |
|
| 4. WIRELESS | RECEIVERS: | GEM- | ||
| 2 LINE KEYPAD |
| RECV96 (64 zones maximum) |
| ||
|
| 5. RELAY MODULE: RM3008 (16 relays maximum) |
| |||
|
|
|
| |||
|
|
| 6. VOICE INTERFACE: |
| ||
| US |
| 7. TELEPHONE INTERFACE: WIZARD IIe |
| ||
ARMED | STAT |
|
| |||
Connect the available devices as shown above to the remote bus terminals (9, 10, 11 & 12). Observe the correct color wire connections. When connecting the keypads, first configure them accordingly (refer to the Keypad Configuration Mode at the back of this manual). Keypads should be located near every exit/entry door. Up to seven keypads may be connected if the longest cable run from the panel, to the farthest keypad (daisy chained or home- run) is less than 1000 feet. The maximum distance for seven keypads is 300 feet using 22 AWG. wire. NOTE: When running keypad wire, avoid wiring parallel to other types of wiring.
EARTH GROUND
Connect the control panel EARTH GROUND screw to a metal
NOTE: Do not use a gas pipe, plastic pipe or AC ground connections.
Wiring Connections: Remote Bus & Earth Ground
LNAPCO Security Systems | X |
