33
6.1OPERATING/LIGHTING INSTRUCTIONS
The
When lit for the first time, the appliance will emit a slight odour for a few hours. This is a normal temporary condition caused by the
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A. This fireplace is equipped with a pilot which must be lit by hand while following these instructions exactly.
B. Before operating smell all around the fireplace area for gas and next to the floor because some gas is heavier than air and will settle on the floor.
C. Use only your hand to turn the gas control knob / | ||||
manual | ||||
not turn by hand, do not try to repair it. Call a qualified | ||||
service technician. Force or attempted repair may | ||||
result in a fire or explosion. |
| PILOT | ||
|
|
| GAS KNOB | BURNER THERMOPILE |
|
|
| THERMOCOUPLE | |
|
|
| AT OFF | |
|
|
|
| |
OL |
|
|
|
|
| N | O |
|
|
HI | F |
|
| |
O | F |
|
| |
|
| P |
|
|
|
| TOLI |
|
|
P |
|
|
|
|
TOLI |
|
|
|
|
D. Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and replace any part of the control system and any gas control which has been under water.
WHAT TO DO IF YOU SMELL GAS:
•Turn off all gas to the fireplace.
•Open windows.
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbour's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
LIGHTING INSTRUCTIONS
WARNING: The gas valve has an interlock device which will not allow the pilot burner to be lit until the thermocouple has cooled. Allow approximately 60 seconds for the thermocouple to cool.
When lighting and
1.STOP! Read the safety information on the operating label.
2.Turn off all electric power to the fireplace.
3.Turn the gas knob clockwise to off.
4.Wait five (5) minutes to clear out any gas. If you smell gas including near the floor, Stop! Follow "B" on the operating label. If you don't smell gas go to the next step.
5.Find pilot located in front of back log.
6.Turn gas knob
7.Depress and hold gas knob while lighting the pilot with the push button ignitor. Keep knob fully depressed for one minute, then release. If pilot does not continue to burn repeat steps 3 through 6.
8.With pilot lit, turn the gas knob
9.If equipped with remote
10.Turn on all electric power to the fireplace.
TO TURN OFF GAS
1.Turn off all electric power to the fireplace if service is to be performed.
2.Push in gas control knob slightly and turn clockwise to off. Do not force.