Napoleon Fireplaces GDS28P manual Installing B Vent, B-Vent, Adapter, Spill, Switch, Wire Access

27

4.7.2 INSTALLING "B" VENT

Follow the instructions of the "B" vent manufacturer for chimney installation.

A.Remove and discard the two combustion air cover plates

and gaskets located on the rear panel of the appliance.

B.	Replace the four screws per side to secure the rear
	panel to the appliance.
C.	Remove the spill switch bracket from the rear of the	COMBUSTION AIR COVER
	adapter.
		PLATES AND GASKET
D.	Gently pull the two wire terminals (located inside the 7"
	flue collar at the top of the appliance) out approximately
	8".
E.	Bring the wires through the lower hole in the adapter and
	out the spill switch opening. To pass the wires through the
	hole more easily, temporarily tape the two terminals together.
F.	With the spill switch opening aligned to the back of the	ADAPTER
	appliance, push the crimped edge of the adapter in to the
	appliance flue collar.	SPILL
G.	Connect the wire terminals to the spill switch and re-secure	SWITCH

the bracket.

H.Secure the terminal block into place as shown with the screw

	supplied.
I.	Unscrew the wire access cover plate from the rear right hand
	side below the firebox. Remove and discard the gasket.
	Remove the knockout from the cover plate and insert the
	protective bushing. Pull both spill switch wires through the
	bushing taking up any slack. Replace the cover plate. Connect one wire end to the terminal block and
	the other end to terminal 1 of the gas valve. Connect the two wires running down the left side of the
	unit from the on/off switch to the remaining tab on the terminal block and to terminal 3 on the gas valve.
	For aesthetics, the adapter
	has been designed to accept a
	standard matte black 7" stove
	pipe and the decorative band		WIRE ACCESS
	(standard with the GS-150KT).
			COVER PLATE
	Both are available from your local	TERMINAL BLOCK

authorized dealer / distributor.

4.7.3 B-VENT

Attach the B-Vent label, shown, in the control area of the appliance.

ATTACH THIS LABEL IN THE CONTROL AREA OF THE FIREPLACE.

THIS FIREPLACE HAS BEEN CONVERTED TO A ‘B’VENT MODEL.

ATTACHEZ CET ETIQUETTE DANS LA REGION DE CONTROLE DU FOYER.

CEFOYERAETECONVERTIAUNMODELEASYSTEMED’EVACUATION‘B’.

WS-385-160

W415-0153 / B / 06.10.10