NCR RealScan 7883 Installation and Owner Guide
Programming Defaults
Scanning the Default programming tag sets most program parameters to the default programmed at the factory. The original defined default values are shown in the chart below. However, some parameters do not have default values so they are not changed, they stay as they are programmed.
01 Communications Protocol |
|
|
Protocol |
| No default value – remains as programmed |
|
|
|
11 Good Read Tone |
|
|
Tone On/Off |
| On |
Tone Frequency |
| Choice 6 of 8 Levels |
Tone Length |
| Choice 3 of 16 Levels |
Tone Volume |
| Choice 4 of 8 Levels |
| Choice 2 of 8 Levels | |
|
|
|
12 Timers |
|
|
Lockout Time |
| 900 Milliseconds |
Restart Lockout Timer |
| Off |
Active Time |
| 15 Minutes |
|
|
|
13 Bar Codes – 1 |
|
|
UPC/EAN |
| Enable |
Extend |
| Disable |
Extend |
| Disable |
Periodical Codes | Disable | |
Periodical Code Extension |
| |
Send Data | Data As Decoded | |
|
|
|
14 Bar Codes – 2 |
|
|
Code 39 |
| Disable |
Minimum Characters Allowed | 8 | |
Full ASCII | Disable | |
Check Digit Present |
| Disable |
Transmit Check Digit |
| Disable |
Allow 1- or |
| Disable |
|
|
|
15 Bar Codes – 3 |
|
|
Interleaved 2 of 5 | Disable | |
Bar Code Length |
| Range Check |
Value 1 | 08 | |
Value 2 | 16 | |
Check Digit Present |
| Disable |
Transmit Check Digit |
| Disable |
|
|
|
17 Bar Codes – 4 |
|
|
Code 128 | Disable | |
Minimum Data Characters | 3 | |
UCC 128 |
| Disable |
|
|
|
16 of 75 | 04/04 |
