
NCR RealScan 7883 Installation and Owner Guide
Calibrating the METTLER TOLEDO® Scale
Before proceeding make sure the scanner is configured for a scale. The programming tag sequence below. If speech is enabled, the
Programming Mode, Hex 3, Hex 0, Hex 3, Save and Reset.
Programming Mode, Hex 3, Hex 0, Hex 1, Save and Reset. (kilograms)
Programming Mode, Hex 3, Hex 0, Hex 2, Save and Reset. (pounds)
1.Use a screw driver or car key to pry up the Top Plate until you can get hold of it, then lift if off the unit.
20220
2.Remove the Calibration Switch cover screw.
Calibration Switch
Cover Screw
20221
3.Press the Calibration Button. One short beep per second starts to sound.
4.Place the Top Plate on the scale. Do not put anything on the Top Plate. It is highly recommended to use the scale display as it has a scale zero switch and prompts for proper weight.
04/04 | 47 of 75 |