NetComm NB712 manual 14.16.11 PAT, After key in enter, the screen will prompt as below

14.16.11 PAT

To configure Port Address Translation, move the cursor “>>” to pat and press enter.

>> clear	Clear virtual server mapping
modify	Modify virtual server mapping
list	Show virtual server mapping pool

You can delete virtual server mapping entry- from 1 to 10- by using clear command. You can create up to 10 virtual server mapping entry via modify command.

----------------------------------------------------------------------

Command: setup ip_share pat modify <1~10>

Message: Please input the following information.

Virtual server entry number <1~10>: 1

----------------------------------------------------------------------

After key in enter, the screen will prompt as below.

>> interface	Active interface
port	TCP/UDP port number
server	Host IP address and port number
protocol	Transport protocol
name	Service name
begin	The schedule of beginning time
end	The schedule of ending time

Set the active interface number via interface command.

You can configure the global port number by using port command.

The local server, host, IP address and port number are configured via server command. The authorized access protocol is setup via protocol command.

Name command can be used to configure the service name of the host server.

Begin and end command is used to setup the local server schedule to access.

You can view the fixed NAT mapping entry via list command.

NB712 /	NB714 User Guide	105
YML829	Rev1