14.16.7 Route
You can setup the routing parameters in route command. If the product is configured as a bridge, you do not want to setup the route parameters. Move the cursor “ >> “ to route and press enter.
>> static | Configure | static routing table |
rip | Configure | RIP tool |
If the Router is connected to more than one network, it may be necessary to set up a static route between them. A static route is a
With Dynamic Routing, you can enable the Router to automatically adjust to physical changes in the network’s layout. The Cable/DSL Firewall Router, using the RIP protocol, determines the network packets’ route based on the least number of hops between the source and the destination. The RIP protocol regularly broadcasts routing information to other routers on the network.
You can setup 20 sets of static route in static command. After entering static menu, the screen will show as follow:
>> add | Add static route entry |
delete | Delete static route entry |
list | Show static routing table |
You can add 20 sets of static route entry by using add command. Type the IP information of the static route including IP address, subnet mask and gateway.
You can delete the static route information via delete command.
You can review the static route entry by using list command.
To configure Routing Information Protocol (RIP), you can use rip command to setup the parameters. Move the cursor “>>” to rip and press enter.
>> generic | Configure operation and auto summery mode |
lan | Configure LAN interface RIP parameters |
wan | Configure WAN interface RIP parameters |
list | Show RIP configuration |
Generic command can setup RIP mode and auto summery mode.
If there are any routers in your LAN, you can configure LAN interface RIP parameters via lan command.
The product supports 8 PVCs and you can configure the RIP parameters of each WAN via wan command. Move the cursor “>>” to wan and press enter.
Command: | setup route rip wan <1~8> <more... | > |
Message: | Please input the following information. | |
Active interface number <1~8>: 1
The screen will display the following:
>> attrib | Operation, authentication and Poison reverse mode |
version | RIP protocol version |
authe | Authentication code |
Attrib | command can configure RIP mode, authentication type and |
Version | Poison reverse mode. |
command can configure RIP protocol version. | |
Authe | command can configure authentication code. |
You can review the list of RIP parameters via list command.
NB712 / | NB714 User Guide | 101 |
YML829 | Rev1 |
|
