NETGEAR WG102NA manual Logging in to the Wireless Access Point

NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual

Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless settings needed to connect to the WG102 Access Point (SSID, WEP/WPA, MAC ACL, etc.), verify connectivity by using a browser such as Netscape or Internet Explorer to browse the Internet, or check for file and printer access on your network.

Note: If you are unable to connect, see Chapter 5, “Troubleshooting

Logging in to the Wireless Access Point

The default IP address of your access point is 192.168.0.229. The WG102 Access Point is set, by default, for the DHCP client to be disabled.

Note: The computer that you use to connect to the WG102 Access Point should be configured with an IP address that starts with 192.168.0.x and a Subnet Mask of 255.255.255.0.

1.Open a Web browser such as Internet Explorer or Netscape Navigator.

2.Connect to the WG102 Access Point by entering its default address of http://192.168.0.229 into your browser.

Figure 1-6

Basic Installation and Configuration 1-9

v1.0, July 2008