![](/images/new-backgrounds/1188955/188955115x1.webp)
NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
•Configure WG102 Access Point (AP 2) on LAN Segment 2 in
•Configure the WG102 Access Point (AP3) on LAN 3 in
2.Verify the following for all access points:
•The LAN network configuration of the WG102 Access Points are configured to operate in the same LAN network address range as the LAN devices
•Only one AP is configured in
•All APs must be on the same LAN. That is, all the APs LAN IP address must be in the same network.
•If using DHCP, all WG102 Access Points should be set to “Obtain an IP address automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings menu.
•All WG102 Access Points use the same SSID, Channel, authentication mode, if any, and encryption in use.
•All
3.Verify connectivity across the LANs.
•A computer on any LAN segment should be able to connect to the Internet or share files and printers with any other PCs or servers connected to any of the three LAN segments.
•Wireless stations will not be able to connect to the WG102 Access Points in the illustration above. If you require wireless stations to access any LAN segment, you can use additional WG102 Access Points configured in Wireless Access Point mode to any LAN segment.
Note: You can extend this
Advanced Configuration |