NETGEAR WG102NA manual Appendix a Factory Default Settings and Specifications

Appendix A Factory Default Settings and Specifications

Factory Default Settings

When you first receive your WG102 Access Point, the default factory settings are set as shown below. You can restore these defaults with the Reset button on the rear panel — see “Rear Panel” on page 1-3.

Feature	Factory Default Settings
User name (case sensitive)	admin
Password (case sensitive)	password
Operating mode	Access point
Access point name	netgearxxxxxx where xxxxxx are the last six digits of the
	wireless access point's MAC address
Built-in DHCP client	DHCP client disabled, it uses the default IP address
IP configuration	IP Address: 192.168.0.229
	Subnet Mask: 255.255.255.0
	Gateway: 0.0.0.0
Network Name (SSID)	NETGEAR-0-0
Broadcast Network Name (SSID)	Enabled
Super-G mode	Disabled
WEP/WPA	Disabled
MAC Access Control	Disabled
Restricting connectivity based on MAC Access	Disabled
Control List
Time Zone	GMT
Time Zone Adjust for Daylight Saving TIme	Disabled
SNMP	Disabled
VLAN (802.1Q)	Disabled
WMM support	Disabled

A-1

v1.0, July 2008