User’s Manual for the NETGEAR Double 108 Mbps Wireless PC Card 32-bit CardBus WG511U

WG511U Default Wireless Configuration Settings

If this is a new wireless network installation, use the factory default settings to set up the network and verify wireless connectivity. If this is an addition to an existing wireless network, you will need to identify the wireless configuration and security parameters already defined.

Your WG511U factory default basic settings are:

Wireless Network Name (SSID): NETGEAR_11g

Note: In order for the WG511U Wireless PC Card to communicate with a wireless access point or wireless adapter, all devices must be configured with the same wireless network name (SSID).

Network Mode (Infrastructure or Ad-hoc): Infrastructure

Data security WPA-PSK encryption: Enabled

Default WPA-PSK passphrase: NETGEAR-ULTRA-G

The section below provides instructions for setting up the WG511U for basic wireless connectivity to an access point. The procedures below provide step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the version of Windows you are using.

Basic Setup

3-3

August 2004

Page 21
Image 21
NETGEAR user manual WG511U Default Wireless Configuration Settings