To create a dial-up connection follow these steps:
1.Give the dial-up connection a name and click Next.
2.Click Next to accept the default modem, or select a modem and configure it, if necessary.
3.Enter the phone number of the modem to which you wish to connect. Click Next.
4.Associate a protocol (RDP or ICA) with your dial-up connection by selecting a session to start. This selection is optional. Click Finish, the Connection Manager displays.
5.Select the dial-up connection and click Connect. A logon panel displays, complete the data fields and click Connect. A “Connecting to...” panel displays, followed by a “Successful Connection” panel, and then a “Duration of Connection” panel.
6.Press CTL+ALT+END to bring up the NCD Connection Manager, select a connection to a server and click Connect (or simply double-click the Name). A logon panel may display before you are connected.
Note The server must be defined with its FQDN (fully qualified domain name, for example, accthydra.ncd.com) or IP Address for the connection to complete.
Switching the Terminal to Dial-Up Mode
Set the terminal to dial-up mode in the Setup Wizard or in the Terminal Properties > Management tab > Network Options panel.
Once the terminal is set to dial-up mode (the terminal restarts for the setting to take effect), the Connection Manager displays, or, if a dial-up connection has not been previously defined, the Make New Dial-Up Connection Wizard displays.
