Nikon F50 instruction manual Using Built-In Flash

5 Fully depress the shutter release button to take a picture. The film automatically advances by one

frame.

-Shutter speed indication without ,,' "should be read as a reciprocal fraction, i.e., "15" stands for 1/15 second, "15" H for 15 seconds.

-In Single Servo AF mode, if a stationary subject moves, remove your finger from the shutter release button, then lightly press it again to restart autofocus.

Using Built-In Flash

Use the built-in flash not only when the ready- light blinks, but also when your subject is in shadow or backlit.

See pages 51 to 55.

Auto Rewind

When the film reaches the end of the roll, auto rewind begins. During rewinding, e and ~ blink in the LCD panel. After rewind automatically stops, frame counter shows E and e blinks for a few seconds. You can then remove film cartridge.

•When battery power is very weak, or when the temperature is very low, fIlm may not rewind at the end of roll; Err appears in the LCD panel. In this case, replace battery with a fresh one, or wait for the temperature to rise and then press the rewind button.

To rewind film at mid-roll: Press the rewind button at the bottom of the camera.

28