Nilfisk-Advance America SW 700S P Before Starting The Machine, Starting And Stopping The Machine

Models: SW 700S P

1 84
Download 84 pages 26.42 Kb
Page 52
Image 52
BEFORE STARTING THE MACHINE

ENGLISH

USER MANUAL

USE

WARNING!

On some points of the machine there are some adhesive plates indicating:

DANGER

WARNING

CAUTION

CONSULTATION

While reading this Manual, the operator must pay careful attention to the symbols shown on the plates. Do not cover these plates for any reason and immediately replace them if they are damaged.

BEFORE STARTING THE MACHINE

1.Make sure that the debris container (17) is properly closed before starting the machine.

2.If necessary, remove the cap (27) and refuel the machine.

CAUTION!

Do not fill the fuel tank beyond the upper limit mark (A, Fig. 1).

STARTING AND STOPPING THE MACHINE

Starting the machine

1.Adjust the handlebar (3) with the knobs (5).

2.Ensure that the side broom (10) is lifted.

3.Open the fuel tap (A, Fig. 2) by introducing the hand into the compartment (29) without opening the hood (7).

4.Turn the engine choke lever (A, Fig. 3) to closed position

(B) by introducing the hand into the compartment (29) without opening the hood (7).

NOTE

Do not close the choke lever if the engine is hot and if the air temperature is sufficiently high.

5.Turn the ignition key (71) to "I".

6.Pull slowly the engine pull-start cord handle (28) until a certain resistance is achieved; then pull suddenly and strongly and start the engine.

CAUTION!

Do not allow the handle (28) to return strongly but bring it back to its position slowly, to prevent the starting system from being damaged.

CAUTION!

When starting the engine with the handle (28) do not pull the drive lever (4).

S311480

Figure 1

S311481

Figure 2

S311482

Figure 3

10

146 0676 000(5)2007-06 A

SW 700S P

Page 52
Image 52
Nilfisk-Advance America SW 700S P Before Starting The Machine, Starting And Stopping The Machine, Starting the machine