ENGLISH
USER MANUAL
DEBRIS CONTAINER EMPTYING
1.Stop the machine by releasing the drive lever (4).
2.Turn the ignition key (61) to "0".
3.Turn on the filter shaker with the handle (20).
4.Disengage the debris container hook (18) by pulling its lower end.
5.With the handle (19) remove the debris container (17) and empty it into an appropriate container.
6.Install the debris container (17) and engage the hook (18).
7.Restart the engine.
8.The machine is ready to start working again.
AFTER USING THE MACHINE
After working, before leaving the machine, perform the following procedures.
1.Clean the dust filter by using the manual filter shaker (20).
2.Empty the debris container (17) (see the procedure in the previous paragraph).
3.Lift the side broom with the knob (12).
4.Remove the ignition key (71).
5.Make sure that the machine cannot move independently.
6.If equipped, press the pedal brake (26).
7.Close the fuel tap (48) in the compartment (29).
PUSHING THE MACHINE
The machine can be pushed both with the ignition key (71) to “0” and to “I”.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
1.Check that the machine storage area is dry and clean.
2.Slightly lift the machine so that the skirts, the main broom and the wheels do not touch the ground.
3.Handle the petrol engine as shown in the relevant Manual.
FIRST PERIOD OF USE
After the first period of use perform the following procedures:
1.After the first 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for integrity and leakage.
2.After the first 20 hours, or after the first month, change the engine oil (see the procedure in the Petrol Engine Manual).
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be defined by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off and, if necessary, the batteries must be disconnected.
Moreover, carefully read all the instructions in the Safety chapter before performing any maintenance procedure.
12
146 0676
SW 700S P
