Nilfisk-Advance America SW 700S P Troubleshooting, Scrapping, English, User Manual

ENGLISH

USER MANUAL

TROUBLESHOOTING

Trouble	Possible cause	Remedy
	The ignition key is not turned to “I”.	Turn the ignition key to "I".
	The engine oil level is low.	Add engine oil. (1)
The engine does not start when pulling the	The fuel tap is closed.	Open the fuel tap.
	The fuel tank is empty.	Refuel.
handle.
	The hood is not properly closed.	Close the hood properly.
	The fuel does not reach the carburettor.	Check if the fuel reaches the carburettor. (1)
	The spark plug does not produce a spark.	Clean/replace the spark plug. (1)
The engine stops during operation.	The engine oil level is low.	Add engine oil. (1)
	The fuel tank is empty.	Refuel.
	The side broom is not lowered.	Lower the side broom.
The side broom does not operate.
	The side broom belt or belt tensioner is not	Contact an authorised Nilfisk-Advance
	efficient.	Service Center.
	The pedal brake (optional) is engaged.	Release the pedal brake (optional).
When pulling the drive lever, the machine does	The driving belt tensioner is not operating.	Contact an authorised Nilfisk-Advance
		Service Center.
not move, or it moves slowly.
	The driving belt is not efficient.	Contact an authorised Nilfisk-Advance
		Service Center.

(1) For the relevant procedure, see the Petrol Engine Manual.

For further information, refer to the Service Manual, available at any Nilfisk-Advance Service Center.

SCRAPPING

Have the machine scrapped by a qualified scrapper.

Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the Law in force:

–Polyester dust filter

–Main and side brooms

–Engine oil

–Plastic hoses and components

–Electrical and electronic components (*)

(*)Refer to the nearest Nilfisk-Advance Center especially when scrapping electrical and electronic components.

20

146 0676 000(5)2007-06 A

SW 700S P