USER MANUAL
ENGLISH
Left skirt
5.Open the hood (7), loosen the knob (A, Fig. 18) and remove the main broom left cover (A, Fig. 19), by pressing it downwards to disengage the fasteners (B).
6.Adjust the height of the left skirt (C, Fig. 19) by using the slots (D).
7.Assemble the components by performing steps 5 to 6 in the reverse order.
Right skirt
8.Remove the main broom as shown in the relevant paragraph.
9.Remove the main broom belt (57) from the pulley (61); for an easier removal, turn the pulley (61) by manually operating on the fan (64).
10.Remove the screws (25) and the right cover (24) together with the belt (57).
11.Adjust the height of the skirt (A, Fig. 20) by using the slots
(B).
12.Assemble the components by performing steps 8, 9 and 10 in the reverse order.
Front and rear skirt check
13.Remove the main broom as shown in the relevant paragraph.
14.Check the front (A, Fig. 21) and rear skirts (B) for integrity.
15.Replace the skirts when they have cuts (A, Fig. 15) larger than 20 mm or cracks/tears (B) larger than 10 mm (for skirt replacement, refer to the Service Manual).
16.Check that:
•The front skirt (A, Fig. 17) slightly touches the floor (as shown in the figure).
•The distance from the ground of the rear skirt (A, Fig.
16)is within 0 - 3 mm (as shown in the figure).
17.If necessary, adjust the skirt height by using the slots on the screws (C and D, Fig. 19).
18.Assemble the components in the reverse order of disassembly.
HOOD SAFETY SWITCH OPERATION CHECK
While the engine is running, slightly open the hood (7) and check that the engine stops immediately.
If the engine keeps running when the hood (7) is open, contact an authorised Service Center or Retailer.
S311471
Figure 18
S311472
Figure 19
S311473
Figure 20
C D
A B
S311474
Figure 21
SW 700S P
146 0676
19