USER MANUAL
ENGLISH
WARNING!
The engine cannot be started with the handle (28) when the hood (7) is open. A safety system prevents the engine from starting.
NOTE
When the engine is running, the main broom turns, while the side broom does not move, if lifted.
7.5 seconds after the engine has been running, disengage the engine choke lever (A, Fig. 3) by introducing the hand into the compartment (29), without opening the hood (7).
8.Release the pedal brake (26) (optional).
9.Lower the side broom (10), then disengage the fastener (2) and lower the knob (12) (without turning it).
NOTE
The side broom (10) can be lifted and lowered even if it is turned on.
10.Pull the drive lever (4) with care until the machine starts to move. The speed is proportional to the pressure applied to the drive lever (4).
Stopping the machine
1.To stop the machine, release the drive lever (4) completely.
2.To turn off the side broom (10) lift the knob (12) (without turning it), and then engage the fastener (2).
3.To turn off the main broom (11) and the vacuum fan (64), turn the ignition key (71) to “0”.
4.Then close the fuel tap (48) in the compartment (29).
MACHINE OPERATION
1.Avoid stopping for a long time with the machine in the same position and the brooms turning: this could create unwanted marks on the floor.
2.For machine proper operation, the dust filter must be as clean as possible. To clean the filter while sweeping, turn on the filter shaker according to the following procedure:
•Pull the handle (20) outward to the end of stroke, then suddenly release it; the inner return spring thus strikes the dust filter frame and shakes it. Repeat this procedure several times.
NOTE
Repeat the filter shaking procedure at least every 10 minutes. This interval can change depending on the dustiness of the area to be cleaned.
NOTE
When the dust filter is clogged and/or the debris container is full, the machine cannot collect dust and debris anymore.
CAUTION!
Do not work on wet floors to prevent the dust filter from being damaged.
3.The debris container (17) should be emptied after each working cycle and whenever it is full.
CAUTION!
The engine is equipped with a warning system to prevent damages to the engine itself in case the oil quantity in the carter is insufficient. Before the oil level goes below the safety limit, the warning system automatically stops the engine.
SW 700S P
146 0676
11
