Option | Description |
|
|
Log | Indicates whether the system is currently recording events. You can enable or disable |
| event logging. By default, it is disabled. |
|
|
Log level | Allows you to configure the event level and filter out unwanted events below this |
| level. The events ranging from the highest critical level “Emergency” down to this |
| configured level will be recorded to the log buffer on the Router’s SDRAM. When |
| the log buffer is full, the newest event will wrap up to the top of the log buffer and |
| overwrite the oldest event. By default, the log level is “Debugging”, which is the lowest |
| critical level. The log levels are defined as follows: |
| Emergency is the most serious event level, whereas Debugging is the least important. |
| For instance, if the log level is set to Debugging, all the events from the lowest |
| Debugging level to the most critical level Emergency level will be recorded. If the log |
| level is set to Error, only Error and the level above will be logged. |
|
|
Display Level | Allows you to select the logged events and displays on the View System Log window |
| for events of this level and above to the highest Emergency level. |
|
|
Mode | Allows you to specify whether events should be stored in the local memory, be sent to |
| a remote syslog server, or to both simultaneously. |
| If remote mode is selected, the view system log will not be able to display events |
| saved in the remote syslog server. When either Remote mode or Both mode is |
| configured, the WEB UI will prompt the you to enter the Server IP address and Server |
| UDP port. |
|
|
3: Click View System Log. The results are displayed as follows.
3G10WV HSPA
