NordicTrack 3G10WV manual Local Area Network LAN, Setting. By default NAT is enabled

7.1Local Area Network (LAN)

This screen allows you to configure the Local Area Network (LAN) interface on your Router.

See the field descriptions below for more details.

Option	Description
IP Address	Enter the IP address for the LAN interface
Subnet Mask	Enter the subnet mask for the LAN interface
Enable UPnP	Tick the box to enable Universal Plug and Play
Enable Half-Bridge	The HSPA 7.2 Mbps Wi-Fi Router can be set up as a half- transparent bridge to
	cope with some special applications such as VPN pass-through. By default half-
	bridge is off. Please refer to Appendix B for more information.
Enable Internet Group	Enable by ticking the box
Management Protocol	Standard Mode: In standard mode, multicast traffic will flood to all bridge ports when
(IGMP) Snooping
	no client subscribes to a multicast group.
	Blocking Mode: In blocking mode, the multicast data traffic will be blocked. When there
	are no client subscriptions to a multicast group, it will not flood to the bridge ports.
Dynamic Host	Select Enable DHCP server and enter your starting and ending IP addresses and
Configuration Protocol	the lease time. This setting configures the router to automatically assign IP, default
(DHCP) Server	gateway and DNS server addresses to every DHCP client on your LAN
Enable NAT	To enable/disable Network Address Translation (NAT, please refer to 7.2 for NAT
	setting). By default NAT is enabled.
Option 42, 66,150,160	These options are used for special DHCP set up.
Static IP Lease List	To specify the IP address assigned through DHCP according to the MAC address
	of the hosts connected to HSPA 7.2 Mbps Wi-Fi Router.

46 – 3G10WV HSPA Wi-Fi Router with Voice