Nortel Networks BMD00007 manual Optional Setup for Telnet Support, # /cfg/sys/access/tnet

Alteon OS Command Reference

3.Next, decide whether to apply the changes at the prompt:

Apply the changes? [y/n]

Enter y to apply the changes, or n to continue without applying. Changes are normally applied.

4.At the prompt, decide whether to make the changes permanent:

Save changes to flash? [y/n]

Enter y to save the changes to flash. Enter n to continue without saving the changes. Changes are normally saved at this point.

5.If you do not apply or save the changes, the system prompts whether to abort them:

Abort all changes? [y/n]

Enter y to discard the changes. Enter n to return to the “Apply the changes?” prompt.

NOTE – After initial configuration is complete, it is recommended that you change the default passwords as shown in “Setting Passwords” on page 43.

Optional Setup for Telnet Support

NOTE – This step is optional. Perform this procedure only if you are planning on connecting to the GbE Switch Module through a remote Telnet connection.

1.Telnet is enabled by default. To change the setting, use the following command:

>># /cfg/sys/access/tnet

2.Apply and save SNMP and /or telnet configuration(s).

>>System# apply

>>System# save

42 „ First-Time Configuration BMD00007, November 2007