Nortel Networks BMD00007 manual Cfg/l2/gvrp, Gvrp Configuration, 42GVRP Menu Options /cfg/l2/gvrp

Alteon OS Command Reference

/cfg/l2/gvrp

GVRP Configuration

[GVRP configuration Menu]
port	- Port menu
jtime	- Set GARP join time
ltime	- Set GARP leave time	time
latime	- Set GARP leave all
dynamic	- Enable/disable dynamic VLAN creation
on	- Globally turn GVRP	On
off	- Globally turn GVRP	Off
current	- Display current GVRP parameters

Use the following commands to configure Generic VLAN Registration Protocol (GVRP).

Table 6-42GVRP Menu Options (/cfg/l2/gvrp)

Command Syntax and Usage

port

Displays the GVRP port menu. To view menu options, see page 239.

jtime <100-65535>

Configures the time interval between GARP Join messages, in milliseconds.

The default value is 200.

ltime <100-65535>

Configures the GARP Leave time value, in milliseconds. The Leave time is the interval the switch waits before removing the port from a VLAN on which it received the Leave message.

The default value is 600.

latime <100-65535>

Configures the time interval for GARP Leave-All messages, in milliseconds.

The default value is 10000.

dynamic enabledisable

Enables or disables dynamic VLAN creation. If you disable dynamic VLAN creation, existing dynamic VLANs persist in the switch, but no new dynamic VLANs are created. To remove all existing dynamic VLANs, turn GVRP off.

on

Globally turns GVRP on. With GVRP on, the GbESM processes GPDUs.

238 „ The Configuration Menu BMD00007, November 2007