100
• Cells | These commands provide information about the cells within the system. | |
|
| |
•• Show cell:_ | Enter the number of the cell you wish to program. | |
|
| |
•• Cell radios | Assign a radio to this cell. | |
|
| |
••• Show radio:_ | Enter the number of the radio. | |
|
| |
•• Cell nghbrs | Assign a cell to be a neighbor. This is a cell that physically adjoins another | |
| cell. | |
|
| |
••• Show nghbr | View neighbor information. | |
|
| |
•• Cell rad nghbrs | Assign a cell to be a bordering cell to each cell neighbour. | |
|
| |
•• Show RadNghbr | View cell radio neighbor information. | |
|
| |
• System LID | Use these commands to determine the System Access Logical Identifier (LID) | |
by which the system identifies itself to portable telephones, and by which the | ||
portable telephones request service from the system. | ||
| ||
|
| |
• Rec’d # length | Select the number of digits received on | |
| These digits are used to identify the Auto DN and DISA DNs, and to route | |
| calls to target lines. | |
|
| |
• DN length:_ | Select the length of DNs. | |
| DN length can be three to seven digits. Each increase in DN length adds the | |
| digit 2 to an existing DN (for example: DN 344, when increased to five digits, | |
| becomes 22344). | |
|
| |
• Nat’nl length | The length of the telephone number dialed to reach a person within the same | |
| country. | |
|
| |
• Make/Break: | Select the Make/Break ratio. The default Make/Break ratio is 40 / 60. | |
|
| |
• BusName | Enter the name of the business. This name displays on the receiving set, | |
| where the line allows. | |
|
| |
• CbC limits | These commands allow you to program the minimum and maximum incoming | |
| and outgoing calls for a PRI line pool. | |
|
| |
•• Pool | Select the PRI line pool | |
|
| |
••• Show: Public | Select Public or Private, or Tie, FX, OUTWATS, 800 | |
|
| |
•••• Min incoming | Enter the minimum number of incoming PRI lines you need. | |
|
| |
•••• Max incoming | Enter the maximum number of incoming PRI lines you need. | |
|
| |
•••• Min outgoing | Enter the minimum number of outgoing PRI lines you need. | |
|
| |
•••• Max outgoing | Enter the maximum number of outgoing PRI lines you need. | |
|
| |
• Release reasons | Release reasons. | |
|
| |
• Hospitality | These commands allow you to create the hospitality settings. | |
|
| |
•• Room/desk information | These commands allow you to assign sets to a room. | |
|
| |
••• Show set:_ | Indicate the set you wish to configure. | |
|
| |
••• Room #:_ | Indicate the room associated with the set. | |
|
| |
••• Adm pwd req’d: | Indicate whether the set requires the use of the Hospitality Desk Admin | |
| password to access Hospitality Desk features. | |
|
|
Modular ICS 6.1 Programming Record | P0603536 02 |