Nortel Networks ICS 6.1 ATA dvc, SM Supervisor, Intrusion, Protect Lvl, Name, User prefernces

84

••••ATA dvc

Set to enhance connectivity for telephones connecting to PRI and BRI lines through an ATA module. Choose Telephon for telephones, and Modem for other devices, such as fax machines.

••• SM Supervisor	Select whether the telephone can be used to perform silent monitoring on
	Hunt groups.
••• Intrusion	Determine what priority an attendant telephone will have to allow a break-in
	by an M1 attendant telephone. To stop break-in, this setting must be higher
	than the attendant level.
•••• Protect Lvl	None, Low, Med, High
•• Name	Enter a one-to-seven-digit name for the telephone.
•• User prefernces	These commands allow you to program the user admin features, such as
	external autodialers, language choice, and display contrast, to personalize
	the operation of the set.
••• Model	Allows you to pre-program a DN to a specific model of Norstar set.
	Note: Use the M7000 model setting to correspond with T7000 Business
	Series Terminals. i.e. M7100/T7100; M7208/T7208; M7310/T7316/T7316E.
	M7324 has no T-series equivalent.
••• Button prgrming	Allows you to program the buttons with internal and external autodialers and/
	or programmed feature keys.
•••• 10+24 buttons	Allows you to choose specific buttons to program, and the number of
	programmable buttons for the set type.
•••• BXX:Blank button	This is the display you see if the button is not assigned.
	Use the Next button to move through the list of buttons available to the set
	model.
•••• BXX:<feature/line/DN>	This is the display you see that indicates what is assigned to the button.
	Soft keys: Clr/Tel#/Featr
••••• Tel # dest’n?	This is the display you receive if you press the TEL# soft key at the button
	prompt.
•••••• Intrnl#:_____	Enter an internal number to attach to this line.
•••••• Extrnl#:____	Enter an external number to attach to this line.
••••• Feature code:	This is the display you receive if you press the FEATR soft key at the button
	prompt. Use the Next button to scroll through the available codes.
	Press OK to assign the feature to the button.
•••••• Speed Dial: F0	Use TEL# soft key to enter number to be dialed when you press this button.
•••••• Send Msg:F1	Send message to another mailbox.
•••••• #Send Msg:F#1	Send message to another telephone display.
•••••• Ring Again:F2	Monitor busy or unanswered telephone or busy line within the system. This
	feature signals you to call back when the telephone or line pool becomes
	available.
•••••• Conf/Trans:F3	Use to establish a three-way call.
•••••• Call Fwd:F4	Send all calls to another telephone within the system.
•••••• Last no.:F5	Last number redial automatically dials the last external telephone number
	that was dialed from this set.
•••••• Page Genrl:F60	See Voice Call

Modular ICS 6.1 Programming Record P0603536 02