Nortel Networks ICS 6.1 Config, Ptl, DS0 rate, TxClk src, TxClk invrsn, Data invrsn, Lp state

	105
•••• Config	Use to configure the settings for the SDI.
••••• Ptl	Select the physical interface used to connect the SDI to the networking
	equipment.
••••• DS0 rate	Select the transmission rate of the channels (Fixed lines) assigned to the SDI.
••••• TxClk src	Select whether data travelling through the SDI is synchronized using timing
	(clocking) from the SDI or the DTE.
••••• TxClk invrsn	Invert the signal used by the SDI to synchronize data from the DTE to adjust
	for round trip delays between the SDI and DTE.
••••• Data invrsn	Invert data travelling through the SDI before routing it to the T1 connection or
	DTE to allow the SDI to support HDLC/SDLC (a transmission standard for
	data) protocol.
•••• Lp state	Show the direction of the loopback, if any, generated by the SDI.
•••• Fixed access	Assign fixed lines to supported data modules:
	• IDM 200
	• BayStack
	• SDI).
• Maintenance	These commands allow you to make diagnostic checks on the system.
• System version	Record the system version shown on the display.
• Port/DN status	View the Port/DN status.
• Module status	View the Module status.
• Sys test log	View items in Sys test log.
• Sys admin log	View items in log.
• Network evt log	View the items in the Network Log.
	This log keeps a record of events and alarms involving the digital network
	interface.
• Provisioning	Place BRI loops in or out of service.
• Tests	Run and list any BERT-set tests.
• CSU stats	View the performance statistics for your T1 lines.
• Diagnostic tools	Diagnostic tools programming performed by experienced personnel.
• Link Status
• Usage metrics
•• Hunt Groups	Use to gather statistical information about Hunt group usage.
•• Call-by-Call	Use to gather statistical information about PRI CbC calls.

P0603536 02 Modular ICS 6.1 Programming Record