Nortel Networks ICS 6.1 Call Restrns, Vacant, Use flt, Mid, Full, Service time, Hour, Minutes

101

•• Call Restrns	These commands allow you to assign dialing filters to room occupancy
	states.
••• Vacant	This command notes if the Room is empty or occupied.
•••• Use flt:	Enter the dialing filter for the room state. The filters range from 00 to 99.
••• Basic	Indicate the filter to be assigned for that level of room occupancy.
••• Mid	Indicate the filter to be assigned for that level of room occupancy.
••• Full	Indicate the filter to be assigned for that level of room occupancy.
•• Service time	These commands allow you to program a system-wide time when occupied
	rooms change state from Service done to Needs service.
••• Hour	Enter the hour.
••• Minutes	Enter the minutes.
•• Alarm	These commands allow you to configure the Alarm operation.
••• Attn attempts	Enter the number of times the Alarm time feature attempts to get the attention
	of the occupant before cancelling.
••• Retry intrvl	Enter the interval period between each Alarm attempt.
	This setting is in minute intervals.
••• Attn duration	Set the period for which a set alerts on each alarm attempt.
	This setting is in seconds.
••• Time format	Choose if alarm times are entered using a 12 hour or 24 hour clock.
•• Expired Alarms	These commands allow you to determine how the system will notify you about
	expired alarms.
••• Notify set	Use this command to choose whether the set where the alarm was
	programmed will be notified if the alarm expires.
••• Use Tone	Use this command to choose what tone will be used if the set is notified that
	an alarm has expired.
• Network services	These commands are used for MCDN connections only.
•• ETSI (profile 2 only)	These features can be supplied by your service provider over ETSI lines.
••• Netwrk Redirection (NCD)	Use this command to indicate whether you want to be able to call forward
	calls over the network.
••• MCID	Use this command to indicate whether the MCID feature code can be used to
	record call information at the CO.
•• MCDN (profiles 1, 2, and 4)	Press Next to move to next entry.
••• NetwkICCL	Select whether you want ISDN Call Control Limitation to be set for your
	MCDN network.
••• TRO	Select whether you want Trunk Route Optimization to be active on the MCDN
	networks.
••• TAT	Select whether you want Trunk Anti-Tromboning to be set for your MCDN
	network.
• SM Sets	Indicate the number of silent monitoring telephones that you want to allow in
	your system (1 - 30). Note that telephones that have been allowed as SM
	supervisors cannot be monitored.

P0603536 02 Modular ICS 6.1 Programming Record