Nortel Networks ICS 6.1 Packet servce, Lp001, TEIs, Tei, ONN blk, SPID2, Cd2 on KSU, Mod, Asm

104

••• D-packet servce	Configure the D-packet service for this loop.
	Only one loop on each card can support D-channel packet service.
•••• D-packet servce	Turn the D-packet service for this loop on or off.
•••• Lp001	Select the loop that supports the D-packet service:
	• S-loop (for BRI-ST Card)
	• LT-loop (for BRI-U2 or BRI-U4 Card)
••• TEIs	Add up to eight Terminal Endpoint Identifiers (TEIs).
	Each TEI is supplied by your service provider. A TEI is associated with an
	ISDN device.
•••• TEI	Enter the two-digit TEIs supplied by your service provider.
••• ClockSrc	Determine the type of clock source.
••• ONN blk	Determine if ONN blocking will be allowed for BRI loops.
••• SPID2	Enter the second SPID supplied by your service provider, if applicable.
• Cd2 on KSU	Select the type of card that occupies the second slot in the ICS.
	Note: The slots are numbered from left to right.
	Version note: If your system is using 4x8 software which has not been
	upgraded, this setting does not appear.
•• Mod 03	View and program the cards installed in the modules.
•• Mod 04	Note: MICS-XC also has modules 9-14.
•• Mod 05
•• Mod 06
•• Mod 07
•• Mod 08
••• StnMod	Indicate that the module is a Station Module
••• ASM	Indicate that the module is an Analog Station Module
••• TrunkMod	Indicate that the module is a Trunk Module
••• DataMod	Indicate that the module is a datamodule:
	• Norstar Integrated Data Module 200 (IDM 200)
	• BayStack
	• Synchronous Data Interface (SDI)
•••• Type	Indicate the type of data module.
	You can change the type if no data module is currently attached to the
	expansion port.
•••• IP address	Indicate the IP address for a data module (BayStack only).
•••• Fixed access	Assign Fixed lines to supported data modules
	• IDM 200
	• BayStack
	• SDI).
•••• Switched access	Assign lines used for dial-up network access to the data module (BayStack
	only).
••••• Line assignment	Select fixed lines the data module (BayStack only) uses for switched access.
••••• Line pool access	Indicate line pool switched access for the data module (BayStack only).
•••• DataMod NVRAM	Use to reset the NVRAM of the IDM 200 data module to the factory defaults.

Modular ICS 6.1 Programming Record P0603536 02