Onkyo Connecting the DV-CP802 Connecting a Stereo Amp, Connecting Components with

Connecting the DV-CP802—Continued

Connecting a Stereo Amp

This section explains how to connect the DV-CP802 to a stereo amp or receiver for sound quality better than that possible with most TV’s built-in speakers. This is great for listening to your CDs and MP3s, and DVDs and VCDs will sound better too. You can also enjoy Dolby Surround, if your amp supports Dolby Pro Logic.

Analog Connection

Use an RCA audio cable to connect the DV-CP802’s ANALOG AUDIO OUTPUT to a pair of analog audio inputs on your amp or receiver, as shown.

Stereo amp	(white)
	L
	R
	(red)

“DTS>PCM” (see page 50). Otherwise an unpleasant digital noise may be heard, which may damage your equipment.

•The output formats for the OPTICAL and COAXIAL digital audio outputs can be set independently (see page 50).

•Never connect the DV-CP802 to the AC-3RF input on a Dolby Digital receiver. The AC-3RF format is not supported by the DV-CP802.

Connecting Components with

With (Remote Interactive) you can control the DV-CP802 by using the remote controller supplied with

your Onkyo -compatible AV receiver.

Onkyo AV receiver

		ANALOG
		INPUT
		RCA cable				REMOTE
	1	(white)	OPTICAL			CONTROL
Signal flow			DIGITAL IN		L
	L
					R
	R				ANALOG
		(red)			INPUT
L
R				To use	you must make
				an analog audio connection
				(RCA) between the DV-CP802
				and the other component,
Notes:				even if they are connected
					digitally.	cable
• Set the Analog Audio Out setting to “2 Channel” (see
						(Supplied)
page 22, 52).
					1
• If your amp has a built-in Dolby Pro Logic decoder, to					L
enjoy DVDs that bear the Dolby Surround logo, set the			AUDIO OUTPUT
Analog Audio Out 2 Channel setting to “Lt/Rt” (see			DIGITAL		R
			OPTICAL	COAXIAL
page 52).
Digital Connection				L
				R		REMOTE
Use an optical (or coaxial) digital audio cable to connect						CONTROL
the DV-CP802’s OPTICAL (or COAXIAL) DIGITAL
AUDIO OUTPUT to an optical (or coaxial) digital audio
input on your amp or receiver, as shown.
			Notes:

OPTICAL	COAXIAL	• Push each plug in all the way to make a good connec-
			tion.
		•	Use only	cables for	connections.
		•	To use	you must make an analog audio connec-
OPTICAL			tion (RCA) between the DV-CP802 and Onkyo AV
			receiver, even if they are connected digitally.

AV receiver

COAXIAL

Signal flow

Notes:

•Be sure to set the Dolby Digital Out setting to “Dolby Digital>PCM,” and set the DTS Out setting to

•The DV-CP802 has two sockets. You can connect either one to the Onkyo AV receiver. The other socket

is for connecting additional -compatible compo- nents.

•Connect the DV-CP802’s sockets to only Onkyo components. Connecting to other manufacturer’s components may cause them to malfunction.

20