Onkyo DV-CP802 instruction manual Setting Levels With the Test Tone, AV Synchronization

Configuring the DV-CP802—Continued

3When you’ve finished, press the

[SETUP] button to exit setup, or

Remote controller

3When you’ve finished, press the

[SETUP] button to exit setup, or

Remote controller

SETUP

Note:

press the Left [] button repeat- edly to go back to the main setup menu.

SETUP

press the Left [] button repeat- edly to go back to the main setup menu.

•The Speaker Distance settings have no effect on SACD (multichannel area and 2-channel area) and 196 kHz/176.4 kHz DVD-Audio.

Setting Levels With the Test Tone

1	Use the Up and Down [ ]/[ ]
Remote controller	buttons to select Test Tone, and
	then press the [ENTER] button.
	The Test Tone settings appear onscreen.
ENTER

AV Synchronization

When using progressive scanning you may find that the picture and sound are out of sync. With this setting you can delay the audio to correct this. There are three setup memories (1, 2, 3) for storing settings for up to three components. Memories 2 and 3 are already set at 50 ms, which is a good staring point when compensating for the video delay caused by a typical projector with a built-in scaler.

ON STANDBY

2

Remote controller

ENTER

Use the Up and Down [ ]/[ ] buttons to select a speaker, press the [ENTER] button, use the Left and Right []/[ ] but- tons to adjust the level, and then press [ENTER] again.

Repeat for each speaker.

A test tone is output by each speaker as it is selected.

Speaker levels can be adjusted in 1 dB steps.

Speaker	Range	Default
Front Left
Center
Front Right	–12 dB to
		0 dB
Surround
	0 dB
Right
Surround Left
Subwoofer

You cannot set the level of speakers that are set to Off.

			OPEN/
			CLOSE
	SEARCH	LAST M MEMORY CHAIN MODE
			REPEAT
	1	2	3
			A-B
	4	5	6
			RANDOM
	7	8	9
			DISPLAY
	+10	0	CLEAR
	TOP MENU		MENU
ENTER
/		ENTER
	RETURN		SETUP
			SETUP
	AUDIO	ANGLE SUBTITLE
	DISC 1	DISC 2	DISC 3 STEP/SLOW
	DISC 4	DISC 5	DISC 6

DISC SKIP PROGRESSIVE DIMMER

RC-521DV

Selecting the AV Synchronization

1	Use the Up and Down [ ]/[ ]
Remote controller	buttons to select setup 1, 2, or 3,
	and then press the [ENTER] or
	Right [ ] button.
ENTER	The parameters appear onscreen.

54