Preparing the remote controller
1 | Detach the battery |
| cover. |
2 | Insert the two R6 |
| (size AA) batter- |
| ies. |
Point the remote controller toward the remote control sensor.
Remote control | |
sensor | |
| m |
| 5 |
| feet) |
About | |
(16 |
|
3
Be sure to match the + and – ends of the batteries with the diagram inside the battery compartment.
Attach the battery cover.
Notes
Notes
•Do not mix new batteries with old batteries or different kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller is not to be used for a long period of time.
•Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, replace both batteries at the same time.
•The life of the batteries supplied is about six months but will vary depending on usage.
•Place the unit away from strong light such as direct sun- light or inverted fluorescent light, which can prevent proper operation of the remote controller.
•Using another remote controller of the same type in the same room or using the unit near equipment that uses infrared rays may cause operational interference.
•Do not put any object, such as a book, on the remote controller. The buttons of the remote controller may acci- dentally be pressed and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation.
•If there is an obstacle between the remote controller and the remote control sensor, the remote controller will not
operate.
13