◆Switching the display information

Pressing DISPLAY on the main unit repeatedly toggles between two types of information display.

FM/AM frequency

Preset channel name (*)

*If a given preset channel is not named, the unit displays “No Name,” then indicates the frequency. See “Naming an MD, and its tracks, and preset channels” on page 52.

◆Using the remote controller

Press the number buttons as described in the examples

below to select the desired preset channel

Preset

Press

channel

88

1010/0

22--/--- ,2 , 2

--/---represents the tens digit.

Adjust the volume level. (Pressing VOLUME increases the volume level, and pressing VOLUME decreases the level.)

Selects an FM/AM station.

Selects a preset channel.

(Pressing selects a lower channel number and pressing

selects a higher channel number.)

Enables you to manually tune in a broadcast station.

(See below.)

◆Manually tuning a broadcast station

You can also tune in radio stations manually.

1Turn on the power to the FR-N3X.

2Select FM or AM.

3Press TUNING or repeatedly while observ- ing the display to tune in the desired frequency. Each press of the button changes the frequency by 50kHz for FM and 9kHz for AM. Pressing and hold- ing down the button for more than one second will change the frequency continuously. While FM is selected, pressing and holding or down a while, then releasing it, will automatically raise (or lower) the frequency.

If FM reception is not good

When an FM stereo broadcast is being received, “ST” lights up on the display. However, if the signal is weak or too much noise interferes, it will not light up. In this case, press MODE to switch to monaural reception.

(“AUTO” turns off.) This could reduce noise and intermittent cut-outs.

To return to AUTO tuning, press MODE again.

25