Rack mounting
The unit can be mounted into a
recommended that the 22 q long Chassis Trak (model number
1
Attach the inner members of the slide rails. Refer to Table 1 for the places where they are to be secured with the screws.
A B C D E F G H
Table 1 Locations where the screws are secured on right (R) side of inner members of slide rails
| 18 q Chassis Trak | 22 | q Chassis Trak |
|
|
| |
Part Number | |||
|
|
|
|
Screw holes to be used | B, E, G | C, | H |
|
|
|
|
Attach the inner members at the same symmetrical positions on the left (L) side.
Note: The letters “A” to “H” are not actually marked on the side panels.
2
3
4
5
The length of the screws used is subject to restriction. Use screws which are less than 10 mm long in their place.
6 screws must be used to secure each inner member. When using the 22q long slide rails, secure the screws at 4 locations.
Attach the outer member brackets to the rack.
Check that the height is the same for the left and right brackets.
Remove the four screws at the front for attaching the left and right side panels.
Attach the
Rack-mounting adapters
Remove the 4 rubber legs from the bottom of the unit, and install the unit in the rack. After the unit has been installed, check that it moves smoothly along the rails.
Standard rack
Fasten it to the rack with set screws.
<Notes>
•Keep the temperature inside the rack to between +5°C and +40°C.
•Bolt the rack securely to the floor so that it will not topple over when the VTR is drawn out.
– 102 –
