Controls and their functions
<Front Panel Centre Section>
]Headphones jack
The sound being recorded, played back or edited can be monitored on stereo headphones when they are connected to this jack.
^Volume control
This is used to adjust the headphones volume and the monitor output volume.
Whether the headphones output and monitor output volumes are to be linked or kept separate can be set on the setup menu No. 713 (MONI OUT). (Note that the headphones output volume is normally linked.)
When the volumes are kept separate, the monitor output is set to the unity value (preset value).
_MONITOR SELECT switches
These are used to select the audio signals output to the monitor L/R channels.
Each time the “L” button is pressed, the signals output to the monitor L channel are selected in turn in the following order: CH1, CH2, CH3, CH4, CH5, CH6, CH7, CH8, CUE
and back to CH1.
[However, this switching is disabled when the channel except OFF has been selected for setup menu No. 734 (MONITOR MIX L).]
Each time the “R” button is pressed, the signals output to the monitor R channel are selected in turn in the following order: CH1, CH2, CH3, CH4, CH5, CH6, CH7, CH8, CUE and back to CH1.
[However, this switching is disabled when the channel except OFF has been selected for setup menu No. 735 (MONITOR MIX R).]
The L or R lamp on the level metre display lights to indicate which signal is now being selected. (When the unit is set to “AUTO” in No. 745 (MONI CH SEL) on the setup menu, then the display will change according to the monitor output.)
The lamp flashes if the channels selected by AUDIO CH SELECT do not appear on the display screen.
`METRE (FULL/FINE) selector switch
This is used to change the scale display (graduations) of the audio level metres.
FULL mode: | Standard scale (from – | ¶ to 0 dB) |
FINE mode: | The scale changes every 0.5 dB. | |
aUser assignment switch
This enables the VTR statuses and programmable menus to be registered. Refer to page 18 for details.
bStatus selector switch
This enables the statuses to be registered by the user assignment switch in 3 ways. Refer to page 18 for details.
cProgrammable menu selector switch
This enables the programmable menus to be registered by the user assignment switch in 4 ways.
Refer to page 18 for details.
dMENU button
When this is pressed, the setup menu appears on the TV monitor (when the HD SDI OUT3, SD SDI OUT3 and VIDEO OUT3 connectors are being used).
The setup menu numbers and items are displayed on the unit’s top front display area. Press the button again to exit the setup menu settings and return to the original status.
– 14 –
