Panasonic AW-HE870N operating instructions  Component output setting Component RGB, Y/Pb/Pr, Y/C

Menu item setting/changing (User Mode)

Component output setting [Component: RGB, Y/Pb/Pr, Y/C]

This enables RGB, Y/Pb/Pr or Y/C to be selected as the component signals which are to be output from the I/F REMOTE connector.

Y/C cannot be selected when “1080i” or “720p” has been selected as the “Video output format (Format)” setting. If “1080i” or “720p” has been selected using the video output format selection function while Y/C is selected, the component output will be changed to Y/Pb/Pr.

(Refer to “Changing the component setting” on page 87.)

AWB/ABB operation status display ON/OFF selection

[Status: Off, On]

(Factory setting: Off)

Using this item, the display of the operation status for AWB (auto white balance adjustment) or ABB (auto black balance adjustment) is set to ON or OFF.

When AWB or ABB is executed with this item set to “On”, the following is displayed.

- 84 -

AWB ACTIVE: This is displayed while AWB is being executed.

AWB OK: This is displayed for 3 seconds after AWB was completed successfully.

AWB NG: This is displayed for 3 seconds after AWB was not completed successfully. (AWB executed while ATW, 3200K, or 5600K is selected)

OUT RANGE RB: This is displayed for 3 seconds after AWB was not completed successfully. (A color that could not be adjusted is displayed with RB)

HIGH LIGHT NG: This is displayed for 3 seconds when adjustment is not possible because the light quantity is too high.

LOW LIGHT NG: This is displayed for 3 seconds when adjustment is not possible because the light quantity is too low.

ABB ACTIVE: This is displayed while ABB is being executed.

ABB OK: This is displayed for 3 seconds after ABB was completed successfully.

IRIS CONTROL NG:

This is displayed for 3 seconds when the iris cannot be controlled by ABB.

OUT RANGE RGB: This is displayed for 3 seconds after ABB was not completed successfully. (A color that could not be adjusted is displayed with RGB)