Precautions for installation

The connection and installation should be done by qualified service personnel or system installers. Refer any servicing to qualified service personnel.

Concerning the mounting screws and drop-prevention wire

Attach the drop-prevention wire as a way to prevent the camera from dropping.

When the unit is to be mounted onto a Panasonic pan-tilt head, use the mounting screws and drop-prevention wire that are supplied with the pan-tilt head.

When the unit is to be mounted onto a surface other than a pan-tilt head, provide your own drop-prevention wire, mounting screws, washers, and camera mounting bracket.

For details of the parts to be provided, refer to the next page.

Before attaching the drop-prevention wire, fit the supplied mounting spacer in the camera mounting screw hole.

Mounting screw (M4) Drop-prevention wire

Mounting spacer (supplied)

Pan-tilt head or

camera mounting bracket

Flat washers

Spring washers

Mounting screws

(Inch screws: 1/4-20UNC)

Note

The mounting spacer must be fitted securely using a flathead screwdriver.

Tightening the mounting screws and mounting spacer

Tighten using the torque levels shown in the table below. After tightening, check for play and unsteadiness.

Screws/Spacer

Clamping torque

 

 

Mounting screws (M4)

1.5N • m (15 kgf • cm)

 

 

Mounting screws (Inch screws)

2.0N • m (20 kgf • cm)

 

 

Mounting spacer

2.0N • m (20 kgf • cm)

 

 

- 13 -

Page 13
Image 13
Panasonic AW-HE870N operating instructions Tightening the mounting screws and mounting spacer