13.4. DISASSEMBLY OF PARTS
13.4.1.Disassembly of Indoor Unit
13.4.1.1.Removal of the Front Panel
1.Push the Front Panel up toward upper side from the horizontal line a little by hand.
13.4.1.2. Removal of Front Grille
1.Remove the Front Panel according to the item 13.5.1.1.
2.Keep the Vertical Louver horizontal.
3.Pull the Screw Caps (two in left and right sides) toward the front side and unscrew the screws inside (one each left and right), and finally unscrew the screw on the right side of the Front Grille (one).
Fig. 1
2.Pull it out by pressing each arm located on left and right sides toward outside.
Fig. 2
Note for Reassembly:
Put each axis into Bearing Ass’y up to the bottom one side by one while keeping the Front Panel horizontal.
Fig. 3
Note for Reassembly:
Insert protruding parts on the reverse side of the panel (both left and right sides), for right side, between the PCB Control Box the Open/Close Motor, and for left side, into the left side of the Heat Exchanger respectively.
Fig. 5
Note for Disassembly:
Removing the Front Panel in advance before removal of Air Filters (two) can make reassembly of the Grille easy.
4.Remove the Front Grille to upside by holding the lower part up a little.
Note for Disassembly:
There are three hooks on the top. Holding the Grille up while holding these hooks down makes its removal easy. Be careful of the hooks that might be hard.
Fig. 6
Note for Reassembly:
Put the Grille back securely until you hear click sound
Fig. 4of all the hooks (three) on the top. Or, it may cause breakdown such as “Front Panel does not open” due to
out of gear of the Front Panel Open/Close Motor.
66