CS-TE9DKE CU-TE9DKE / CS-TE12DKE CU-TE12DKE

13.4.2.4. Removal of Control Board

1.Remove the Cabinet Top Plate and Cabinet Front Plate according to the item 13.5.2.1.

2.Remove the Power Supply Cover (2- / 3-way valve Covers and Terminal Cover) according to the item 13.5.2.2.

3.Remove the Control Plate Casing according to 13.5.2.3.

4.Remove Outdoor Air Temp. Sensor and its fitting by releasing the hooks (two) the fitting.

7.Remove the Control Box by releasing the hooks (four) the Box (Control Board Lower Cover).

Note for Disassembly:

Be careful of hanging-up of connectors or wiring cables such as the earth wire when the Box (Control Board Lower Cover) is removed.

Fig. 12

8.Replace the Control Plate Casing (Black plastic part) together when the Control Board needs to be replaced.

Fig. 9

5.Place the Control Box reversely and remove the Screws (Two) on the both sides of the Control Box (for Terminal Plate).

Fig. 10

6.Remove the Control Plate Casing (Terminal Plate) from the Control Plate Casing.

Note for Disassembly:

Remove Power supply terminal (red, white and black) from the Terminal Plate.

Fig. 11

Fig. 13

Note for Disassembly:

Replacement of the Outdoor Control Board should be made as a whole unit due to silicon pasting, etc. although it can be separated PCB part from Control Box part by removing the screws (six) on the soldering side.

72