13.4.1.3. Removal of Control Board

1.Remove the Front Panel according to the item 13.5.1.1.

2.Remove the Front Grille according to the item 13.5.1.2.

Fig. 7

3.Remove the Control Cover.

Note for Disassembly:

There are hooks on both sides (left and right).

Fig. 8

4. Pull out the Control Board.

CS-TE9DKE CU-TE9DKE / CS-TE12DKE CU-TE12DKE

••CN-FM (White) ...... Indoor Fan Motor

••CN-ION (White) ...... Ionizer

••CN-DISP (green or yellow) ...... Control Board (Receiver & Display Unit)

Note for Disassembly:

The CN-TH (yellow) can not be disconnected from Control Board. Remove whole plastic part by releasing the hooks (two) for the Receiver & Display Unit (Board-in).

Fig. 10

Note for Disassembly:

Disconnect the connectors while holding the hooks down. Do not pull it out directly.

Wiring cables from the Terminal Board

••TAB1 terminal (brown) ...... Disconnect the terminal.

••TAB2 terminal (white) ...... Disconnect the terminal.

Note for Disassembly:

Disconnect the terminals while holding the convexity down in the center of each terminal.

••H1 (black), H3 (red) are soldered on PCB. .........

Remove it from the PCB by desoldering.

Fig. 9

5. Remove a variety of Connectors and Terminals.

Wiring parts from the upper side

•• CN-STM2 (blue)

Front Panel Open/Close Motor

Fig. 11

 

••CN-TH (yellow) ...... Intake Air / Pipe Temp. Sensor

Note for Disassembly:

The CN-TH (yellow) can not be disconnected.

Disconnect thermosensitive part of the Pipe Temp.

Sensor from the holder (Board-in). The Intake Air

Temp. Sensor can be easily disconnected.

Wiring cables from lower side

••CN-STM1 (White) ...... Air Swing Motor for Vertical Louver

67