13
VQT4C76
∫Inserting the battery
Open the LCD monitor and install the battery
by inserting it in the direction shown in the
figure.
≥Insert the battery until it clicks and locks.
∫Charging the battery
ADC input terminal
1Connect the AC cable to the AC
adaptor, then the AC outlet.
2Connect the AC adaptor to the DC input
terminal.
≥The status indicator will flash red at an
interval of 2 seconds (a pproximately 1
second on, 1 second off), indicating that
charging has begun. It will turn off when
the charging is completed.
∫Inserting/removing an SD card
≥Check that the access lamp has gone off.
1) Open the SD card cover and insert/
remove the SD card into/from the card
slot.
≥Face the label side B in the direction
shown in the illustration and press it
straight in as far as it will go.
≥Press the center of the SD card and then
pull it straight out.
2) Press the C part of the SD card cover
and close the SD card cover.
≥Securely close it until it clicks.
Quick Guide
Access lamp [ACCESS] A
≥When this unit is accessing the SD
card or built-in memory, the access
lamp lights up.
HC-X900M&X800P&PC&PU-VQT4C76_mst.book 13 ページ 2012年1月11日 水曜日 午後10時6分