46
VQT1A15
Recording
ªScreen indications in the disc recording mode
ARecording mode
BRemaining time left for recording
(When the remaining time is less than
1 minute, [R0min] flashes red.)
CRecording time elapsed
≥The maximum number of scenes on a disc (per
side): 999 (Even if there is remaining capacity
for recording on a disc, you may not be able to
record 999 scenes.)
≥The maximum number of recordable scenes
with different dates (on one side of the disc): 99
(In some cases, scenes recorded on the same
day will be recorded with different dates
(l72))
≥Discs with more than the maximum scenes or
dates cannot be used with this unit.
≥Sound is recorded from the internal
microphones on the top of this unit. Take care
not to block this microphone.
≥Put the unit in pause mode when connecting or
disconnecting an external microphone with the
MIC terminal. If an external microphone is
connected or disconnected while recording, the
audio will not be recorded properly.
≥Each time the unit is put into recording pause,
the counter display will be reset to “0h00m00s”.
≥While motion picture recording is in progress,
the recording will not stop even if the LCD
monitor is closed and the viewfinder is
retracted.
≥While “WRITING CONTROL DATA TO THE
DISC. DO NOT SHAKE THE UNIT.” is
displayed, do not disconnect the AC adaptor or
remove the battery as doing so may make the
disc unusable.
≥While motion picture recording is in progress,
do not disconnect the AC adaptor or remove
the battery. If you do, a repair disc message
may be displayed when the power is turned
back on. (l109)
B
C
A
The ACCESS/PC lamp lights immediately
after recording finishes. While it lights, the disc
is rotating and disc information is being
recorded. If you run while holding the unit or
swing it, the recorded images may be
distorted so do not strongly shake or cause
impact to it.
VQT1A15ENG.book 46 ページ ２００７年１月２９日　月曜日　午後８時２４分