Others

Problem

Check points

This unit cannot be

≥The unit cannot be operated unless you open the LCD monitor or

operated though it is

extend the viewfinder.

 

turned on.

≥Press the RESET button. (l 116) If normal conditions are not

This unit does not

restored yet, remove the battery or AC adaptor, wait about 1 minute

and then reconnect the battery or AC adaptor. Then about 1 minute

operate normally.

later, turn on the power again. (Conducting the above operation

 

when the access lamp is on may destroy the data on the disc or SD

 

card.)

 

The remote control does

≥Has the button-type battery of the remote control run out?

 

not function.

# Replace it with a new button-type battery. (l 19)

 

The DISC EJECT lever

≥The disc cover will not open unless the unit is powered.

 

does not work.

# Connect a charged battery or AC adaptor.

 

 

≥The DISC EJECT lever does not work when the unit is connected to

 

the computer.

 

 

# Disconnect the USB cable.

 

The screen has changed

≥Has the demonstration started?

 

suddenly.

# If you set [DEMO MODE] to [ON] without inserting a disc or an

 

SD card in recording mode, the unit is automatically set to the

 

demonstration mode for introducing its functions. Normally this

 

should be set to [OFF]. Press the MENU button, then select

 

[SETUP] # [DEMO MODE] # [OFF] and press the cursor

 

button.

 

A function indication

≥If you set [SETUP] > [DISPLAY] > [OFF], indications other than

such as the remaining

warnings and date indications disappear.

 

time indication or the

 

 

elapsed time indication is

 

 

not shown.

 

 

The disc cannot be read.

≥Are there fingerprints or dirt on the surface of the disc?

 

 

# If there are fingerprints or dirt on the disc, wipe them off. (l 25)

Recording does not start

≥Has the DVD-RW, DVD-R or DVD-R DL been finalized?

 

although power is

# After finalizing, the discs become play-only and cannot record. If

supplied to this unit and

you un-finalize a DVD-RW, it can be used for recording. (l 82)

the disc or SD card is

≥Has the SD card’s write protect switch been set to LOCK?

 

correctly inserted.

# No recording is possible while the write protect switch is set to

 

LOCK. (l 24)

 

 

≥Is the memory of the disc or SD card full?

 

 

# If the disc or SD card has no more available memory, free up

 

some memory by deleting unnecessary scenes (l 75, 77) or

 

use a new disc or SD card.

 

 

≥Is the unit set to the recording mode?

 

 

# No recording is possible unless the mode dial is at

.

 

≥Is the disc cover open?

 

 

# If the cover is open, this unit may not operate normally. Close the

 

disc cover.

 

 

 

 

 

 

113

VQT1A15

Page 113
Image 113
Panasonic HDC-DX1 operating instructions 113