With a computer
Connection and recognition
Connection and recognition procedures
≥If the recognition procedure is not accomplished properly, operation will not be possible after connecting the unit to the computer.
≥If the unit fails to operate normally it may mean that the correction procedure was not conducted properly.
1Connect this unit to the AC adaptor.
≥If a battery is used, operation is not possible when this unit is connected to a computer.
2Insert an SD card with recorded images in this unit and then set the mode dial to PC to turn on the power.
PC 
3Connect this unit and a computer.
A
AUSB cable (supplied)
This unit is automatically recognised by the computer.
≥Insert the plugs as far as they will go. The unit and computer will not operate properly
if the plugs are not inserted fully. ≥Do not use any other USB connection
cables except the supplied one. (Operation is not guaranteed with any other USB connection cables.)
≥When the unit is connected to a computer, the operation mode cannot be changed and its power cannot be turned off.
In this case, disconnect the USB cable. (l 99) ≥When this unit is connected to a computer, you cannot use this unit’s DISC EJECT lever to
remove a disc.
≥When a computer is accessing the SD card in this unit, the card access lamp lights. (When a
card is being accessed, 
appears on the LCD monitor.) Do not disconnect the USB cable or AC adaptor while the disc or card is being accessed as it may damage the data.
≥It may be necessary to reboot the computer after connecting this unit to it for the first time.
97
