Power supply (continued)

Using an AC power supply

(When the AJ-B75 AC adapter is used)

1Connect the DC OUT connector on the AJ-B75 AC adapter to the DC IN socket on the unit.

DC IN socket

2

3

Set the power of the AC adapter to ON.

Set the unit’s power switch to ON.

<Notes>

O Check the pin signals of the DC IN socket when using an external power supply other than the AJ- B75 AC adapter. (DC 12 V, 8.5 A)

Supplying +12V power to the GND terminal by mistake may give rise to ignition, resulting in a fire, or it may cause injury.

O Power from the AC adapter takes precedence when both a battery pack and AC adapter have been connected.

O When using the AC adapter, be absolutely sure to first set the power of the AC adapter to ON and then set the unit’s power switch to ON.

If the power is turned on in the reverse sequence, the output voltage of the AC adapter will rise gradually, and the unit may malfunction as a result.

Pin no.

Signal

1

GND

2, 3

==

4

+12 V

1

2

3

4

25