Error messages
Display message Cause/solution
Base no power
or
No link. Re-connect
base AC adaptor.
or
No link.
RThe handset has lost communication with the
base unit. Move closer to the base unit and try
again.
RUnplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
RThe handset’s registration may have been
canceled. Re-register the handset (page 33).
RWhen “No link.” is displayed during a
power failure, place a handset on the base
unit to supply power to the base unit.
Busy RThe called unit is in use.
ROther units are in use and the system is busy.
Try again later.
RThe handset you are using is too far from the
base unit. Move closer and try again.
Call phone company for
your access #
RYou have not stored the voice mail access
number. Store the number (page 45).
Check tel line RThe supplied telephone line cord has not been
connected yet or not connected properly.
Check the connections (page 9).
Error!! RRecording was too short. Try again.
Invalid RThere is no handset registered to the base
unit matching the handset number you
entered.
RThe handset is not registered to the base unit.
Register the handset (page 33).
Requires subscription
to Caller ID.
RYou must subscribe to a Caller ID service.
Once you receive caller information after
subscribing to a Caller ID service, this
message will not be displayed.
Use rechargeable
battery.
RA wrong type of battery such as Alkaline or
Manganese was inserted. Use only the
rechargeable Ni-MH batteries noted on page 4,
6.
For assistance, please visit http://www.panasonic.com/help 51
Useful Information