Answering System
3Enter your remote access code within 10 seconds after the long beep.
R The greeting message is played back.
R You can either hang up, or enter your remote access code again and begin remote operation (page 41).
Answering system settings
Number of rings before the unit answers a call
You can change the number of times the phone rings “Ring count” before the unit answers calls. You can select 2 to 7 rings, or “Toll saver”.
The default setting is “4 rings”.
“Toll saver”: The unit’s answering system answers at the end of the 2nd ring when new messages have been recorded, or at the end of the 5th ring when there are no new messages. If you call your phone from outside to listen to new messages (page 41), you know that there are no new messages when the phone rings for the 3rd time. You can then hang up without being charged for the call.
1MMENUN#211
2MbN: Select the desired setting. a MSAVEN a MOFFN
For voice mail service subscribers
If you subscribe to a
R To use the voice mail service provided by your service provider/
telephone company rather than the unit’s answering system, turn off the answering system (page 38).
R To use this unit’s answering system
rather than the voice mail service provided by your service provider/ telephone company, please contact your service provider/telephone company to deactivate your voice mail service.
If your service provider/telephone company cannot do this:
–Set this unit’s “Ring count” setting so that this unit’s answering system answers calls before the voice mail service of your service provider/telephone company does. It is necessary to check the number of rings required to activate the voice mail service provided by your service provider/telephone company before changing this setting.
–Change the number of rings of the voice mail service so that the answering system can answer the call first. To do so, contact your service provider/telephone company.
Caller’s recording time
You can change the maximum message recording time allowed for each caller. The default setting is “3 min”.
1MMENUN#305
2MbN: Select the desired setting. a MSAVEN a MOFFN
Selecting “Greeting only”
You can select “Greeting only” which sets the unit to announce a greeting message to callers but not record messages.
Select “Greeting only” in step 2 on “Caller’s recording time”, page 43.
For assistance, please visit http://www.panasonic.com/help | 43 |
