FUNAI DRV-B2734, DRV-B2737 Channel setting, Auto tuning, Manual tuning, Press Setup to exit

DRV_B2737_B2734.book Page 18 Thursday, March 31, 2005 10:04 PM

Getting Started

Channel setting

Tuning of this unit to broadcast channels can be performed in two ways.

Auto tuning

Programme the tuner to scan only the channels you can receive in your area.

1 Press [STANDBY-ON] to turn on the unit.

2 Turn the TV on and select the input to which the unit is connected.

3 In stop mode, press [SETUP].

“Easy Setting Menu” or “Advanced Setting Menu” will appear.

4 Select “Channel” using

[Cursor U / D], then press [ENTER].

5 Select “Auto Tuning” using [Cursor U / D], then press [ENTER].

The unit will start storing channels available in your area.

P 01

Auto Tuning Now

Wait for several minutes to finish channel storing.

6 Press [SETUP] to exit.

You can select only the channels memorized in this unit by using [PROG. U / D].

To select a channel

You can select a channel using [PROG. U / D], or directly enter the channel using

[the Number buttons] on the remote control.

To cancel auto tuning

Press [RETURN R] or [SETUP] during scanning.

Note

•The selection will be affected by how you receive TV channels in your local area.

•If the auto tuning is cancelled during scanning, some channels not yet tuned may not be received.

•You cannot change the channel when either VCR or DVD is in any recording mode (normal recording, one-touch timer recording or timer recording).

EN 18

Manual tuning

Manually tune each channel.

1 In stop mode, press [SETUP].

“Easy Setting Menu” or “Advanced Setting Menu” will appear.

2 Select “Channel” using

[Cursor U / D], then press [ENTER].

3 Select “Manual Tuning” using [Cursor U / D], then press [ENTER].

Manual TuningVCR DVD

Position	P01
Channel	12
Decoder	OFF
Skip	OFF

4 Select “Position” using

[Cursor U / D], then press [ENTER].

5 Select the position number you wish to use using [the Number buttons] or [Cursor U / D], then press [RETURN R].

You can select position numbers 01 to 99.

6 Select “Channel” using

[Cursor U / D], then press [ENTER].

7 Press [Cursor U / D] to start scanning.

• The tuner will begin to search up or down automatically. When a channel is found, the unit will stop searching and the picture will appear on the TV screen.

• You can select a desired channel number using [the Number buttons]. Refer to the following Channel Plan table and press the three digits to select the channel number.

(To select channel 4, press [0] first and then press [0] and [4], or press [4]. Or press [4] and then “– – 4” appears and wait for 2 seconds.)

• If this is the channel you want, press [RETURN R].

Channel Plan

Ch. Indication		TV Channel
01	- 10	IRA - IRJ, GAP
21	- 69	E21 - E69
74	- 78	X, Y, Z, Z+1, Z+2
80 - 99, 100		S1 - S20, GAP
121	- 141	S21 - S41

This unit can receive the Hyper and Oscar frequency bands.