FUNAI DRV-B2737, DRV-B2734 Installation Location, Avoid the Hazards of Electrical Shock and Fire

Models: DRV-B2734 DRV-B2737

1 76
Download 76 pages 15.47 Kb
Page 3
Image 3

DRV_B2737_B2734.book Page 3 Thursday, March 31, 2005 10:04 PM

A NOTE ABOUT RECYCLING

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

When discarding the unit, comply with your local rules or regulations. Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

Make your contribution to the environment!!!

• Exhausted batteries do not belong in the dustbin.

You can dispose of them at a collection point for exhausted batteries or special waste.

Contact your council for details.

For Customer Use:

Carefully read the Model No. and Serial No. located at the back of the unit and enter the information below. Retain this information for future reference.

Model No. _____________________

Serial No. _____________________

Installation Location

For safety and optimum performance of this unit:

Install the unit in a horizontal and stable position.

Do not place anything directly on top of the unit.

Do not place the unit directly on top of the TV.

Shield the unit from direct sunlight and keep away from sources of intense heat. Avoid dusty or humid locations. Avoid locations with insufficient ventilation for suitable heat dissipation. Do not block the ventilation holes on the sides of the unit. Avoid locations subject to strong vibration or strong magnetic fields.

Avoid the Hazards of Electrical Shock and Fire

Do not handle the mains cable with wet hands.

Do not pull on the mains cable to disconnect it from AC outlet. Grasp it by the plug.

If, by accident, water is spilled on the unit, unplug the mains cable immediately and take the unit to an Authorized Service Centre for servicing.

Connection to Power

Before Switching on make sure that the voltage of your electricity supply is the same as that indicated on the rating plate.

Mains Cord

This appliance may be fitted with a non-rewireable plug. If it is necessary to change the fuse in a non- rewireable plug the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug must not be used until a replacement available from the appliance manufacturer is obtained.

It is important that the colour of the replacement fuse cover corresponds with the rating marking on the base of the plug.

If the plug has to be changed because it is not suitable for your socket, or becomes damaged, it should be cut off and an appropriate plug fitted following the wiring instructions below. The plug removed must be disposed of safely as insertion into a 13A socket is likely to cause an electrical hazard. For your own safety read the following instructions carefully before attempting to connect this unit to mains.

The wires in this mains lead are coloured in accordance with the following code:

BLUE=NEUTRAL, BROWN=LIVE

Important

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:-

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

No connection is to be made to the earth terminal of the plug.

If a 13 Amp (BS 1363) Plug is used, a 3 Amp Fuse must be fitted, or if any other type of Plug is used a 3 or 5 Amp Fuse must be fitted, either in the Plug or Adaptor, or on the Distribution Board.

Mains Supply:220 - 240 V 50 Hz - AC only

Do not make any connection to the larger pin marked

with the letter “E” or by the symbol or coloured green or green and yellow.

Before you start

Moisture Condensation Warning

Moisture condensation may occur inside the unit when it is moved from a cold place to a warm place,

BLUE

(Neutral)

FUSE

BROWN (Live)

CORD GRIP

after heating a cold room, or under conditions of high humidity. Do not use the unit for at least 2 hours to allow the inside to dry.

OUTER SHEATH OF THE WIRE

3

EN

Page 3
Image 3
FUNAI DRV-B2737, DRV-B2734 Installation Location, Avoid the Hazards of Electrical Shock and Fire, Connection to Power