FUNAI DRV-B2734 Timer recording, Enter the date using Cursor U / D, then press Cursor P

DRV_B2737_B2734.book Page 28 Thursday, March 31, 2005 10:04 PM

Note

•You cannot use the pause function during one-touch timer recording.

•The unit will be turned off automatically under the following conditions.

-No space remains on the disc.

-If a power failure occurs.

•If DVD one-touch timer recording is completed during VCR playback or recording, the DVD will be in stop mode and the VCR keeps the current mode.

•When one-touch timer recording is finished and the power is turned off, the unit will switch to the timer- standby mode automatically if a timer recording has been programmed. Press [T-SET]to cancel the timer-standby mode to use the unit continuously.

Recording

Timer recording

Video	VR		VCR
DVD-RW	DVD-RW	DVD-R

You can set the unit to record up to 8 programmes, up to a month in advance. Daily or weekly programme recordings are also available.

•Be sure to set the clock before entering a timer programming.

•You can select the timer programming list by pressing [TIMER PROG.]. In this case, continue from step 5.

Insert a recordable disc or a tape with a record tab.

1 In stop mode, press [SETUP].

2 If you select “Advanced Setting Menu,” proceed to step 3.

If you select “Easy Setting Menu,” proceed to step 4.

3 Select “Recording” using

[Cursor U / D], then press [ENTER].

4 Select “Timer Programming” using [Cursor U / D], then press [ENTER].

The Timer Programming list will appear.

5 Select a programme that is not set using [Cursor U / D], then press [ENTER].

Timer Programming				VCR	DVD
Date Start End	CH	DVD	Speed PDC
		VCR

1.- - -

2.- - -

3.- - -

4.- - -

5.- - -

6.- - -

7.- - -

8.- - -

6 Enter the date using [Cursor U / D], then press [Cursor P].

Each time you press [Cursor D] at the current date, the timer recording mode will change as follows.

e.g., 1st January

01/01

D

Daily

D

M-F (Mon.-Fri.)

D

W-SAT

D

W-FRI

D

DW-SUN

D

31/01

EN 28