FUNAI DRV-B2737, DRV-B2734 owner manual To select a channel, To skip a Preset channel, Move

In stop mode, press [SETUP].

Select “Skip” using [Cursor U / D], then press [ENTER].

Follow steps 1 to 3 in “Manual tuning.”

Select “Position” using

[Cursor U / D], then press [ENTER].

DRV_B2737_B2734.book Page 19 Thursday, March 31, 2005 10:04 PM

•If “Skip” is set to “ON,” select “Skip” using [Cursor U / D], then press [ENTER]. Select “OFF” using [Cursor U / D], then press [RETURNR].

•If you want to decode scrambled signals, select “Decoder” using [Cursor U / D], then press [ENTER]. Select “ON” using [Cursor U / D], then press [RETURN R].

•To store another channel, repeat steps 4 to 7.

8 After completion, press [SETUP] to exit.

To select a channel

Notes on using the Number buttons:

•Enter channel numbers as a two-digit number for the quickest result. For example, to select channel 6, press [0] and [6]. If you only press [6], channel 6 will be selected after 2 seconds. You can only select channels 1 to 99.

•You can select the external input mode “AV1,” “AV2” or “AV3.”

•To select “AV1,” press [0], [0], [1].

•To select “AV2,” press [0], [0], [2].

•To select “AV3,” press [0], [0], [3].

3 Select “Channel” using

[Cursor U / D], then press [ENTER].

4 Select “Move” using [Cursor U / D], then press [ENTER].

5 Select the position number of which you want to change the channel using [Cursor U / D], then press [ENTER].

You cannot select a position number where “– – –” appears next to the number, because “Skip” is set to “ON” for that position number.

6 Move the channel to another position number using [Cursor U / D], then press [ENTER].

• To move another channel, repeat steps 5 to 6.

7 Press [SETUP] to exit.

Getting Started

To skip a Preset channel

You can set the unit to skip channels you can no longer receive or seldom watch when you access channels using [PROG. U / D].

1

2

3 Select the position number you wish to skip using [the Number buttons] or [Cursor U / D], then press [RETURN R].

4

5 Select “ON” using [Cursor U / D], then press [RETURN R].

• To skip another channel, repeat steps 2 to 5.

6 Press [SETUP] to exit.

Move

You can replace two channels.

1

2 Select “Advanced Setting Menu” using [Cursor U / D], then press [ENTER].

If it has already appeared, proceed to step 3.

19 EN